|
SHEET
MATERIALS, STRUCTURES AND OTHER BASIC
RAW MATERIALS AND IN PROCESS FABRICATION
- Test
certificate is obtained from the main producers for physical and Chemical
properties.
- We
also send a strip of the raw material to reputed laboratories for
Physical and Chemical Properties
- The
materials are checked physically and visually at producers place and
checked again at our stores on receipt of materials.
- The
materials are finally inspected on fabrication, by our quality control
department with the customer/inspecting authority before despatching
to the Galvaniser.
- The
materials are offered for final inspection to the customer at the
Galvaniser's place, after Galvanising with prior intimation.
INSTRUMENTS
AVAILABLE AT OUR WORKS FOR CHECKING
- Micrometer-1",
2", 4", 6", 12"-Mitutoyo Make
- Vernier
Caliper-6", 12", 18", 24"-Mitutoyo Make
- Surface
Place-600 mm-Guidy Make
- Height
Gauge-14"-Mitutoyo Make
- ALCOMETER
(Coat Gauge)
- All
other standard measuring instruments like:-
Scale,
Tapes, Gauges etc. available
|
1
No. each
1 No. each
1 No. each
1 No. each
1 No. each
|
INSTRUMENTS
AND TESTING AVAILABLE WITH THE GALVANISERS
- Full
fledged Laboratories with all laboratory instruments
- Alcometer
- Knife
for Hammer Test
- Hydrogen
Test Instrument
- Hammer
for Hammer Test
APPROVED
TESTING LABORATORIES WHERE OUR TESTING ARE DONE
- TCR
- Geo-Chem
Laboratories (MULUND)
- Jewel
MetalloChem Laboratories (GHATKOPAR)
|